1. Check the mechanical, electrical, instrumentation and safety protection devices before starting the Hot Air Stenter . According to the process requirements, set the temperature, and then turn on the circulating fan. In the heating stage, the host speed is 15m/min, and the set temperature can be reached. After meeting the requirements of the upper cloth, open the active brush wheel, press the cloth on the needle plate, try to make both sides flush, and at the same time put down the passive brush wheel and tighten the fabric. When starting the host, you should first ring the bell to inform the tail operator. When you put it to the rear of the car, you should wear the cloth at the fastest speed and tighten the fabric. The rear personnel should cooperate with each other before calling.
2. The safety cover of the machine should be in good condition to prevent the needle cloth from hanging around the sleeves, and also avoid the chain break and fly out and hurt people.
3. The rolling rope pull emergency stop switch and the feeding insurance are reliable and useful. When the cloth is operated, it must be stopped. Rolling up the upper roller should not be negligent.
4. The grey cloth must be seamed and not allowed to be knotted to avoid damage to the rubber roller.
5. Before shutting down Hot Air Stenter, the cooling should be reported to the hot-loaded heat transfer furnace room. Then stop the circulating fan operation, open the door to cool down, and run the main engine and the top exhaust fan separately, and the temperature can be reduced to 80 °C before stopping, which can avoid uneven heating of the chain clothing.
6. Regularly check the heat transfer oil pipeline in the oven. If there is oil leakage, it should be dealt with in time. After the shift, the fly flower should be cleaned, and the fly and oil in the exhaust pipe should be cleaned regularly to eliminate the fire hazard.
Zhejiang LICHENG PrintingDyeing Machinery Technology Co., Ltd located in China, offering an exclusive range of Hot Air Stenter Machine which is used for several applications. Our products are highly durable and available in various designs.
Hot Air Stenter Machine is a machine or apparatus for stretching or stentering fabrics. The purpose of the Hot Air Stenter Machine is to bringing the length and width to predetermine dimensions and also for heat setting and it is used for applying finishing chemicals and also shade variation is adjusted. The main function of the Hot Air Stenter Machine is to stretch the fabric widthwise and to recover the uniform width.
Apart from what have discussed in the previous article, when you operate Hot Air Stenter, you should also pay attention to:
1.Regularly check the heat transfer oil pipeline in the oven. If there is oil leakage, it should be dealt with in time. After the shift, the fly flower should be cleaned, and the fly and oil in the exhaust pipe should be cleaned regularly to eliminate the fire hazard.
2.Add a steam pipe on the exhaust pipe at the top of the oven, which can be cooled by steam. When the temperature inside the machine is 165 °C, the steam valve is in the normally open state; the wire radiator is installed on the heat sink to prevent the flying flower or fabric from falling. The heat sink causes burning.
3.When cleaning or refueling, you must turn off Hot Air Stenter Machine. It is strictly forbidden to smash the chain, the brush board, and the rubbing roller (especially the upper and lower rolling bars) when driving to prevent the fingers from being injured. When cleaning on the machine or in the machine or repairing the car, the parking sign must be hung on the console to prevent others from driving.
4.It is strictly forbidden to place any items and food in the oven, on the distribution box and on the machine. If you intersted in LiCheng Hot Air Stenter or Flat Screen Printing Machine , please check below link: https://www.hotairstenter.com/product/hot-air-stenter.html